Triton 360
Save money by calling and asking about our Triton 360 Maintenance Plan today!
Triton 360 Furnace Maintenance
Confirm Furnace Efficiency
Safety Inspection of Heat Exchanger
Adjust Fan Speed for the Quietest Operation
Confirm Age & Condition of Equipment
Confirm Age & Condition of Thermostat
Full Furnace Check
- Confirm age and condition of thermostat
- Confirm thermostat accuracy. Calibrate if needed/possible
- Adjust fan speed for the quietest operation (if possible)
- Confirm furnace efficiency
- Safety inspection of heat exchanger
- Confirm overall condition and age of equipment
- Confirm proper filter size and install standard 1″ or 2″
- Check integrity & construction of return platform to ensure it meets safety standards
- Confirm and inspect interior and exterior upper and lower combustion vents for obstruction
- Inspect blower wheel condition
- Clean blower motor vents and oil motor (if applicable)
- Inspect shaft end play
- Test furnace run assist condition
- Vacuum and remove debris from furnace platform
- Confirm child safety return air door switch is functional
- Confirm there is circuit board / ignition surge protection
- Clean flame sensor rod (if applicable) and confirm its operation
- Clean condensate line and trap (for 90%) efficiency models)
- Confirm gas line meets current earthquake and safety standards
- Cycle unit and check for flame roll out & distributions in flames shape and color
- Perform inlet & manifold gas pressure test
- Confirm proper drafting of flue vent
- Inspect supply and return grills for obstructions
- Inspect ducts for obstructions
- Visually inspect accessible ductwork & plenum for breaks, construction, insulation & air leaks
- Inspect overall ductwork condition
- Inspect attic insulation
- Confirm flue vent is up to current code for safety
- Confirm the temperature rise within manufactures spec
Triton 360 A/C Maintenance
Inspect Supply & Return Air Grills for Obstructions
Inspect Overall Ductwork Condition
Confirm Outdoor Unit Efficiency
Inspect Attic Insulation
Confirm Age & Condition of Thermostat
Full A/C Check
- Confirm age and condition of thermostat
- Confirm thermostat accuracy. Calibrate if needed/possible
- Inspect supply & return air grills for obstructions
- Inspect ducts for obstructions
- Visually inspect accessible ductwork & plenum for proper insulation
- Visually inspect accessible ductwork & plenum for breaks, construction, insulation & air leaks
- Inspect overall ductwork condition
- Inspect attic insulation
- Perform static pressure test (every other year)
- Clean condensate line with Co2
- Confirm outdoor unit efficiency
- Confirm overall condition and age of outdoor unit
- Visually inspect for refrigerant leaks at outdoor unit
- Confirm unit has refrigerant lock-out caps to meet safety and code standards
- Oil outdoor fan (if applicable) and check for proper blade balance/vibration
- Perform amp draw test on outdoor fan motor
- Perform amp draw test on compressor
- Confirm line set at outdoor unit for proper insulation
- Cursory refrigerant level check using line temperature method
- Digital test of refrigerant with precise computer gauge for low operating costs and max performance (performed every other year)
- Tighten electrical connections that disconnected and electrical contacts
- Confirm fuses and circuit breaks meet manufactures specs
- Inspect for excessive pitting, overheating and burnt contacts
- Inspect and test outdoor run assist
- Inspect and test start assist
- Hydro wash outdoor coil – we do not recommend using any chemical cleaners
- Inspect corrosion inhibitors
- Ensure compressor crankcase heaters are operational
- Observe outdoor operating noise level
- Confirm outdoor unit is properly leveled
Reach out and become a member now!
